Download PDF
J Knee Surg 2021; 34(14): 1592-1598
DOI: 10.1055/s-0040-1710564
Original Article

Factors Influencing the Valgus Cut Angle—during Total Knee Arthroplasty—in Indian Population

Sanjiv Marya
1   Bone and Joint Institute, Medanta—The Medicity, Gurgaon, Haryana, India
,
Chandeep Singh
1   Bone and Joint Institute, Medanta—The Medicity, Gurgaon, Haryana, India
,
Shitij Kacker
1   Bone and Joint Institute, Medanta—The Medicity, Gurgaon, Haryana, India
,
Sarthy Velayutham
1   Bone and Joint Institute, Medanta—The Medicity, Gurgaon, Haryana, India
,
Rahul Desai
1   Bone and Joint Institute, Medanta—The Medicity, Gurgaon, Haryana, India
› Author Affiliations Funding None.
› Further Information
    Permissions and Reprints

Abstract

The number of total knee arthroplasties performed in India and the world is increasing exponentially. The valgus cut angle (VCA) of the distal femur decides the final alignment achieved in the coronal plane. Little data are available regarding the ideal value for an Indian population and there is little consensus whether to use a single value for all knees or to individualize the angle for each patient. The parameters that can influence the value of this angle have not been evaluated thoroughly.

Standard long leg X-ray (orthoscanogram) was used to calculate the VCA in 302 lower limbs (160 patients). Only Indian patients were included in the study; knees with bowed femurs were excluded. VCA, femoral length, medial hip offset, neck shaft angle, and hip knee ankle angle were measured manually. Demographic data such as gender, height, and weight were extracted from hospital charts. The correlation of VCA with the various parameters was evaluated using Pearson's correlation and its significance assessed using the independent Student's ‘t’ test.

The average VCA was 7.4 degrees (range: 4–11 degrees). Age, gender, height, hip knee ankle angle (alignment) and body mass index (BMI) had no influence on the VCA. The neck shaft angle (r = –0.520, p = < 0.0001) and hip medial offset (r = 0.223, p = < 0.0001) were the only two parameters significantly and independently influencing the value of VCA. There is a wide variation in the value of VCA in the Indian population. Choosing a fixed VCA will lead to significant number of knees aligned outside the ideal 0- to 3-degree hip knee ankle angle. The neck shaft angle and the medial hip offset are the only two factors that influence the VCA. The patients' height, preoperative deformity, gender, and BMI had no influence on the VCA.

Keywords

valgus cut angle - hip medial offset - femoral bowing - total knee arthroplasty - neck shaft angle - alignment


Publication History

Received: 06 September 2019

Accepted: 31 March 2020

Article published online:
19 May 2020

© 2020. Thieme. All rights reserved.

Thieme Medical Publishers, Inc.
333 Seventh Avenue, 18th Floor, New York, NY 10001, USA

 

  • Reference

  • 1 Bardakos N, Cil A, Thompson B, Stocks G. Mechanical axis cannot be restored in total knee arthroplasty with a fixed valgus resection angle: a radiographic study. J Arthroplasty 2007; 22 (06, Suppl 2): 85-89
    CrossrefPubMedGoogle Scholar
  • 2 Stickley CD, Wages JJ, Hetzler RK, Andrews SN, Nakasone CK. Standard radiographs are not sufficient for assessing knee mechanical axis in patients with advanced osteoarthritis. J Arthroplasty 2017; 32 (03) 1013-1017
    CrossrefPubMedGoogle Scholar
  • 3 Moreland JR, Bassett LW, Hanker GJ. Radiographic analysis of the axial alignment of the lower extremity. J Bone Joint Surg Am 1987; 69 (05) 745-749
    CrossrefPubMedGoogle Scholar
  • 4 Mullaji AB, Marawar SV, Mittal V. A comparison of coronal plane axial femoral relationships in Asian patients with varus osteoarthritic knees and healthy knees. J Arthroplasty 2009; 24 (06) 861-867
    CrossrefPubMedGoogle Scholar
  • 5 Maini L, Singh S, Kushwaha NS. et al. Radiographic analysis of the axial alignment of the lower extremity in Indian adult males. J Arthrosc Jt Surg 2015; 2: 128-131
    CrossrefPubMedGoogle Scholar
  • 6 Howell SM, Papadopoulos S, Kuznik K, Ghaly LR, Hull ML. Does varus alignment adversely affect implant survival and function six years after kinematically aligned total knee arthroplasty?. Int Orthop 2015; 39 (11) 2117-2124
    CrossrefPubMedGoogle Scholar
  • 7 Mahaluxmivala J, Bankes MJ, Nicolai P, Aldam CH, Allen PW. The effect of surgeon experience on component positioning in 673 Press Fit Condylar posterior cruciate-sacrificing total knee arthroplasties. J Arthroplasty 2001; 16 (05) 635-640
    CrossrefPubMedGoogle Scholar
  • 8 Ritter MA, Faris PM, Keating EM, Meding JB. Postoperative alignment of total knee replacement. Its effect on survival. Clin Orthop Relat Res 1994; (299) 153-156
    PubMedGoogle Scholar
  • 9 Thienpont E, Cornu O, Bellemans J, Victor J. Current opinions about coronal plane alignment in total knee arthroplasty: a survey article. Acta Orthop Belg 2015; 81 (03) 471-477
    PubMedGoogle Scholar
  • 10 Matsuda S, Kawahara S, Okazaki K, Tashiro Y, Iwamoto Y. Postoperative alignment and ROM affect patient satisfaction after TKA. Clin Orthop Relat Res 2013; 471 (01) 127-133
    CrossrefPubMedGoogle Scholar
  • 11 Liu H-X, Shang P, Ying X-Z, Zhang Y. Shorter survival rate in varus-aligned knees after total knee arthroplasty. Knee Surg Sports Traumatol Arthrosc 2016; 24 (08) 2663-2671
    CrossrefPubMedGoogle Scholar
  • 12 Kim Y-H, Park J-W, Kim J-S, Park S-D. The relationship between the survival of total knee arthroplasty and postoperative coronal, sagittal and rotational alignment of knee prosthesis. Int Orthop 2014; 38 (02) 379-385
    CrossrefPubMedGoogle Scholar
  • 13 Zhou K, Zhou Z, Shi X. et al. Effect of individual distal femoral valgus resection in total knee arthroplasty for patients with valgus knee: a retrospective cohort study. Int J Surg 2018; 52: 309-313
    CrossrefPubMedGoogle Scholar
  • 14 Kharwadkar N, Kent RE, Sharara KH, Naique S. Five degrees to 6 degrees of distal femoral cut for uncomplicated primary total knee arthroplasty: is it safe?. Knee 2006; 13 (01) 57-60
    CrossrefPubMedGoogle Scholar
  • 15 Zhou K, Ling T, Xu Y. et al. Effect of individualized distal femoral valgus resection angle in primary total knee arthroplasty: a systematic review and meta-analysis involving 1300 subjects. Int J Surg 2018; 50: 87-93
    CrossrefPubMedGoogle Scholar
  • 16 Nam D, Maher PA, Robles A, McLawhorn AS, Mayman DJ. Variability in the relationship between the distal femoral mechanical and anatomical axes in patients undergoing primary total knee arthroplasty. J Arthroplasty 2013; 28 (05) 798-801
    CrossrefPubMedGoogle Scholar
  • 17 Deakin AH, Basanagoudar PL, Nunag P, Johnston AT, Sarungi M. Natural distribution of the femoral mechanical-anatomical angle in an osteoarthritic population and its relevance to total knee arthroplasty. Knee 2012; 19 (02) 120-123
    CrossrefPubMedGoogle Scholar
  • 18 Tang WM, Zhu YH, Chiu KY. Axial alignment of the lower extremity in Chinese adults. J Bone Joint Surg Am 2000; 82 (11) 1603-1608
    CrossrefPubMedGoogle Scholar
  • 19 Wang Y, Zeng Y, Dai K, Zhu Z, Xie L. Normal lower-extremity alignment parameters in healthy Southern Chinese adults as a guide in total knee arthroplasty. J Arthroplasty 2010; 25 (04) 563-570
    CrossrefPubMedGoogle Scholar
  • 20 Kobayashi H, Akamatsu Y, Kumagai K, Kusayama Y, Aratake M, Saito T. Influence of coronal bowing on the lower alignment and the positioning of component in navigation and conventional total knee arthroplasty. Orthop Traumatol Surg Res 2017; 103 (02) 251-256
    CrossrefPubMedGoogle Scholar
  • 21 Rebal BA, Babatunde OM, Lee JH, Geller JA, Patrick Jr DAJ, Macaulay W. Imageless computer navigation in total knee arthroplasty provides superior short term functional outcomes: a meta-analysis. J Arthroplasty 2014; 29 (05) 938-944
    CrossrefPubMedGoogle Scholar
  • 22 Kinzel V, Scaddan M, Bradley B, Shakespeare D. Varus/valgus alignment of the femur in total knee arthroplasty. Can accuracy be improved by pre-operative CT scanning?. Knee 2004; 11 (03) 197-201
    CrossrefPubMedGoogle Scholar
  • 23 Neil MJ, Atupan JB, Panti JPL, Massera RAJ, Howard S. Evaluation of lower limb axial alignment using digital radiography stitched films in pre-operative planning for total knee replacement. J Orthop 2016; 13 (04) 285-289
    Google Scholar
  • 24 McGrory JE, Trousdale RT, Pagnano MW, Nigbur M. Preoperative hip to ankle radiographs in total knee arthroplasty. Clin Orthop Relat Res 2002; (404) 196-202
    CrossrefPubMedGoogle Scholar
  • 25 Swanson KE, Stocks GW, Warren PD, Hazel MR, Janssen HF. Does axial limb rotation affect the alignment measurements in deformed limbs?. Clin Orthop Relat Res 2000; (371) 246-252
    CrossrefPubMedGoogle Scholar
  • 26 Jiang CC, Insall JN. Effect of rotation on the axial alignment of the femur. Pitfalls in the use of femoral intramedullary guides in total knee arthroplasty. Clin Orthop Relat Res 1989; (248) 50-56
    PubMedGoogle Scholar
  • 27 Koshino T, Takeyama M, Jiang LS, Yoshida T, Saito T. Underestimation of varus angulation in knees with flexion deformity. Knee 2002; 9 (04) 275-279
    CrossrefPubMedGoogle Scholar
  • 28 Rivière C, Ollivier M, Girerd D, Argenson JN, Parratte S. Does standing limb alignment after total knee arthroplasty predict dynamic alignment and knee loading during gait?. Knee 2017; 24 (03) 627-633
    CrossrefPubMedGoogle Scholar
  • 29 Parratte S, Pagnano MW, Trousdale RT, Berry DJ. Effect of postoperative mechanical axis alignment on the fifteen-year survival of modern, cemented total knee replacements. J Bone Joint Surg Am 2010; 92 (12) 2143-2149
    CrossrefPubMedGoogle Scholar
  • 30 Bonner TJ, Eardley WGP, Patterson P, Gregg PJ. The effect of post-operative mechanical axis alignment on the survival of primary total knee replacements after a follow-up of 15 years. J Bone Joint Surg Br 2011; 93 (09) 1217-1222
    CrossrefPubMedGoogle Scholar
  • 31 Bellemans J, Colyn W, Vandenneucker H, Victor J. The Chitranjan Ranawat award: is neutral mechanical alignment normal for all patients? The concept of constitutional varus. Clin Orthop Relat Res 2012; 470 (01) 45-53
    CrossrefPubMedGoogle Scholar
  • 32 Tan H, Wang Y, Long T, Nie B, Mao Z, Yue B. How to accurately determine the distal femoral valgus cut angle in the valgus knee arthroplasty. Int Orthop 2018; 42 (03) 537-542
    CrossrefPubMedGoogle Scholar