Key-words:
Cement leakage - navigation - neurological deterioration - radiculopathy - revision
- vertebroplasty
Introduction
Osteoporotic vertebral fractures are a widespread problem in the elderly population.[[1]] Surgical treatment, such as vertebroplasty or kyphoplasty, leads to immediate pain
relief and maintains a standard therapy in osteoporotic fractures.[[2]] In experienced hands, this procedure is a safe and minimally invasive technique.
Nevertheless, in rare cases, severe complications may occur. Besides typical surgical
complications such as infection and bleeding, cement leakage may lead to neurological
deterioration ranging from pain to severe motor deficits.[[3]],[[4]] We present a case report of L5 nerve root compression after cement leakage and
the successful tubular decompression through a Wiltse approach using spinal navigation.
Case Report
History and presentation
A 86-year-old female patient was treated by uniportal right vertebroplasty of a fractured
L5 vertebral body in an external hospital. The day after surgery, the patient showed
a foot flexion paresis on the right side. Besides the neurological deficit, intractable
L5 radicular pain (visual analog scale 8) was the major reason to transfer the patient
to our department 5 days postoperatively. Computed tomography (CT) scans of the lumbar
spine revealed extraforaminal extravasation of the cement around the right nerve root
L5 causing significant compression [[Figure 1]]. The decision to do a minimally invasive decompression through a Wiltse approach
was communicated to the patient and she agreed to the surgical intervention. In general,
the approach is performed with the use of fluoroscopic guidance to accomplish a cranial-lateral
direction to the exiting nerve root due to the iliac crest. To avoid radiation to
the staff and to speed up the procedure, we used spinal navigation to introduce the
tube-like retractor and to identify the cement extravasation nearby by the right nerve
root L5.
Figure 1: Intraoperative computed tomography (axial/sagittal) showing the cement leakage at
the L5 nerve root
The image guidance setup at our department consists of an intraoperative CT (iCT,
SOMATOM Definition AS, Siemens Healthcare GmbH, Erlangen, Germany) and the Spine and
Trauma 3D Navigation Software with the corresponding navigation system (Brainlab AG,
Feldkirchen, Germany).
Operative procedure
The patient was in prone position under general anesthesia. After maintaining sterile
conditions, the reference array was attached to the iliac crest with two pins at the
left side and a sterile drape covered the patient. The position of the patient was
then referenced to the CT position. Low-dose iCT of the field of interest was made.
After image acquisition, a 1-mm axial reconstruction of the affected region was sent
to the navigation system. After accuracy verification, skin incision was made following
the navigation monitor and according to the classic Wiltse approach [[Figure 2]]. After blunt transmuscular preparation, the tube-like retractor (Pipeline®, DePuy
Synthes, Raynham, MA, USA) was placed, and the position was checked with navigation
instead of fluoroscope. Under the microscope, sharp dissection of muscle was performed,
and a small portion of the lateral aspect of the facet joint was removed with the
burr and the Kerrison rongeurs. After bony facet decompression, the cement extravasation
was identified, and the cement plombage was removed with additional decompression
of the nerve root until the pedicle was visible [[Figure 3]]. Sterile iCT was performed and after good decompression was confirmed the wound
was closed in typical fashion [[Figure 4]]. The intraoperative loss of blood accounted approximately 30 ml and the procedure
lasted 35 min from incision to skin suture.
Figure 2: Multiplanar 3D navigation monitor for planning the skin incision
Figure 3: Multiplanar 3D navigation monitor showing the pointer on the cement plombage
Figure 4: Postoperative computed tomography (axial/sagittal) after removal of the cement plombage
Postoperative course
Postoperatively, the radicular pain was resolved (visual analog scale 1) and the motor
weakness improved significantly on the 1st day after the revision surgery. Due to
the significant improvement of the symptoms, no further radiological scans except
the iCT [[Figure 4]] were necessary. The patient was discharged 3 days postoperatively.
Discussion
Vertebroplasty is a widely used procedure to treat osteoporotic vertebral body fractures.
Immediately, pain relief can be achieved and the procedure is safe and fast. Common
complications such as infection, neurological deterioration, and relevant embolism
are rare. Complications such as cement extravasation occur in about 54%; however,
in most of the cases, these complications are asymptomatic.[[5]] In case of cement leakage, the compressions of the spinal cord and/or the nerve
roots may result in severe clinical deterioration. Symptoms such as hypesthesia, radicular
pain, or paraplegia are found and sometimes lead to surgical revision. Three aspects
are important to reduce the risk of complications.
-
Correct introduction of the Jamshidi needle through a transpedicular/extrapedicular
way important
-
The viscosity of the cement is an important detail, ranging from low to high viscosity.
Different factors such as chemical structure of the polymethylmethacrylate and time
point of injection influence the viscosity
-
If cement leakage is recognized, it is important to stop injection immediately. Changing
and replacing the intraoperative fluoroscopic beam path might identify cement leakage
sooner, for example, through the canal of the basivertebral vena.
Conclusion
We present a case of an extraforaminal cement leakage with compression of the nerve
root after vertebroplasty. With the use of spinal navigation, we could identify the
cement plombage in a minimally invasive fashion and resection and decompression was
successful. The patient experienced immediate pain relief and improvement of foot
flexion paresis. Low radiation dose for the operation stuff and sufficient decompression
can be achieved with iCT in a safe and fast approach.
Study Design
This was an observational case study.
Declaration of patient consent
The authors certify that they have obtained all appropriate patient consent forms.
In the form, the patient has given her consent for her images and other clinical information
to be reported in the journal. The patient understand that her name and initials will
not be published and due efforts will be made to conceal their identity, but anonymity
cannot be guaranteed.
